Dieser Shop benötigt aktiviertes JavaScript. Cette boutique nécessite JavaScript activé. Questo negozio richiede JavaScript attivato. This shop requires JavaScript to be enabled.
Receivers (283 results)
Spektrum Receiver AR8020T DSMX 8 channel Telemetry Compatible with all Spektrum DSM2 and DSMX transmitters With full-range telemetry, integrated barometer to provide altitude and vario telemetry data without additional sensors The tying button allows for easy tying and eliminates the need for a tying plug Two external antennas ensure reliable RF coverage from all angles of the aircraft Advanced programming for setting individual failsafe parameters per channel and more Operating voltage: 3.5 - 9 V
Spektrum Receiver AR620 Suitable for most model aircraft, including indoor sports models Antenna-less design for easier installation and full range Integrated flight log and receiver voltage monitoring via telemetry, data transmission to a Spektrum remote control system Rounded lightweight housing Large binding button eliminates the need for a binding plug Supports low latency of 11 ms and standard 22 ms pulse rates
Jeti Receiver Duplex REX 10 Assist 2.4 GHz EX Telemetry data and up to 16 stabilized channels for model aircraft and multicopters Supports various copter configurations, from tricopter to octocopter, LED light strips based on WS2812 chips and external camera gimbals with servos Facilitates flying in windy or difficult conditions, aerobatic maneuvers are more accurate and therefore easier to fly without the need for complex setting of mixers Up to 3 adjustable flight modes with options for horizon stabilization and flight altitude Fine adjustment of stabilization settings in flight via a separate channel Use of 3-axis gyroscopes and 3-axis accelerometers
Jeti Receiver Duplex REX 7 2.4 GHz EX, 200 mm antennas Bidirectional transmission Compatible with Duplex 2.4 EX and EX-Bus protocol Supports telemetry PPM input/output, UDI digital output and integrated expanders for EX/EX bus devices 2 antennas, each 200 mm long Suitable for use with a Jeti DS/DC transmitter or transmitter module
Jeti Receiver Duplex REX 10 2.4 GHz EX Bidirectional transmission Compatible with Duplex 2.4 EX and EX-Bus protocol Supports telemetry PPM input/output, UDI digital output and integrated expanders for EX/EX bus devices 2 antennas, each 20 cm long Suitable for use with a Jeti DS/DC transmitter or transmitter module
Spektrum Receiver AR630+ AS3X+/SAFE 6-channel Number of channels: 6 Modulation: DSMX Application: Model aircraft Built-in AS3X+ stabilization system with SAFE flight environment protection AS3X+ and SAFE setup through forward programming directly from your Spektrum transmitter Ready for use with Spektrum Smart ESCs for one-wire telemetry data without modules, links and wires
Jeti Receiver Duplex R5L 2.4 GHz EX Bidirectional transmission Compatible with Duplex 2.4 EX and EX-Bus protocol Supports telemetry Low susceptibility to interference and high range Power is supplied via one of the 5 servo connections Suitable for use with a duplex TX transmitter module
Spektrum Receiver AR637T+ 6 channel DSMX Number of channels: 6 Modulation: DSM2/DSMX Application: Model aircraft AS3X+ and SAFE setup through forward programming directly from your Spektrum transmitter The binding button makes binding easy and eliminates the need for a binding plug
Jeti Receiver Duplex R9 2.4 GHz EX Compatible with Duplex 2.4 EX and EX-Bus protocol Fully digital and bidirectional communication between transmitter and receiver Supports telemetry PPM input (Sat1) 2 antennas, each 20 cm long Suitable for operation with a duplex Tx transmitter module
Jeti Receiver Duplex REX 6 2.4 GHz EX Bidirectional transmission Compatible with Duplex 2.4 EX and EX-Bus protocol Supports telemetry PPM input/output, UDI digital output and integrated expanders for EX/EX bus devices 2 antennas, each 10 cm long Suitable for use with a Jeti DS/DC transmitter or transmitter module
Jeti Power supply S BEC Power supply for receiver and servos Input voltages from 2S to 10S Li-XX cells possible Adjustment of output voltage from 5 to 8 V by jumper Also suitable for servos with higher voltages Maximum current of up to 12 A - ideally suited for medium and larger models
Futaba Receiver R3008SB Suitable for airplanes and helicopters Support for T-FHSS S.BUS support and 8 PWM channels Light weight of only 11 g
Spektrum Receiver AR631+ 6 channel DSMX Number of channels: 6 Modulation: DSM2/DSMX Application: Model aircraft 230 mm antenna for more versatile installation options Built-in AS3X+ stabilization system with SAFE flight range protection AS3X+ and SAFE setting by forward programming directly from your Spektrum transmitter
Jeti Battery switch Central Box 220 + 2x Rsat2 + RCSW Wirelessly programmable via the device overview of the DC/DS transmitters Fused servo outputs (for 11 servos with ~30 kg actuating force and 4x ~50 kg) Battery connections 2x MPX plug-in system Rugged aluminum housing for extra cooling and protection Firmware upgradeable via Jeti USB adapter and Jeti Studio Up to 3 independent receiver inputs (R1, R2, E1/R3), up to 15 servo slots (suitable for DITEX servo telemetry) and up to 3 telemetry sensor inputs (E1/R3, E2/15, E3/14)
Spektrum Receiver AR8360T+ 8 channel DSMX Number of channels: 8 Modulation: DSMX Application: Model aircraft The binding button makes binding easy and eliminates the need for a binding plug Two external antennas provide reliable RF coverage from all angles of the aircraft Additional RF path redundancy with an additional SRXL2 remote receiver (sold separately)
Futaba Receiver R2008SB Uses serial data communication For airplanes and helicopters Not suitable for use with large models
Jeti Receiver Duplex REX 7 Assist 2.4 GHz EX Telemetry data and up to 16 stabilized channels for model aircraft and multicopters Supports various copter configurations, from tricopter to octocopter, LED light strips based on WS2812 chips and external camera gimbals with servos Facilitates flying in windy or difficult conditions, aerobatic maneuvers are more accurate and therefore easier to fly without the need for complex setting of mixers Up to 3 adjustable flight modes with options for horizon stabilization and flight altitude Fine adjustment of stabilization settings in flight via a separate channel Use of 3-axis gyroscopes and 3-axis accelerometers
Spektrum Receiver AR10360T+ 10 channel DSMX Number of channels: 10 Modulation: DSM2/DSMX Application: Model aircraft Compatible with all Spektrum DSM2 and DSMX transmitters AS3X+ and SAFE setup through forward programming directly from your Spektrum transmitter Compact footprint suitable for most park flyers, sports class and giant models
Powerbox Systems Battery switch Pioneer + MicroSwitch 14 channel Powerful battery backer with high continuous load capacity Consistently double design of the power electronics Redundant electronic switch Full operability from the transmitter for PowerBox and Jeti Latest iGyro technology integrated, with the iGyro Sat as gyro sensor 9 independent gyro outputs for: 3x aileron, 3x elevator, 3x rudder
Jeti Power supply MAX BEC 2 12A For powering receiver and servos using NiXX and Li-XX cells Linear voltage stabilizer with jumper adjustable output voltage: 5 V / 5.4 V / 5.7 V or 6 V Indication of the used capacity of the batteries by means of four LEDs To increase safety, the ON state is achieved with the MPX jumper removed High dielectric strength (up to 12-cell NiXX) and low current in OFF state (170 uA) Analog voltage stabilization prevents radio interference
Powerbox Systems Switch DigiSwitch V2 JR/JR Powerful electronic switch with lightweight and compact design Supported batteries: 2S LiPo, 2S LiIon, 2S LiFePo and 5 cells NiMH Operating voltage: 4.0 V - 9.0 V Output voltage: 6.0 V / 7.0 V / 7.6 V stabilized or unregulated Current carrying capacity: max. 10 A Telemetry support for CORE
Jeti Anti-flash connector Anti Spark 5.5 mm Avoids the annoying and plug-destroying flashing when plugging the battery into the controller Support capacitors on the controller are protected ASC socket with special SMD resistors ASC socket is soldered to one of the controller cables (plus or minus, depending on personal pin assignment) Compatible with existing 5.5 mm gold plugs/sockets
Spektrum Receiver AR410 Suitable for most model aircraft, including indoor sports models Antenna-less design for easier installation and full range Integrated flight log and receiver voltage monitoring via telemetry, data transmission to a Spektrum remote control system Rounded lightweight housing Large binding button eliminates the need for a binding plug Supports low latency of 11 ms and standard 22 ms pulse rates
Jeti Switch RCSW Switch Wireless switch for Jeti BEC stabilizers and central box Compatible devices: SBEC 40, DPS 40, SPS 20, DSM 10, Central Box 200, Central Box 400 and Master Switch Easily controllable with DC/DS transmitter Indication of the switching status by means of red LED For more comfort
Jeti Satellite receiver Rsat 900 MHz NG Supports telemetry Designed for operation with a transmitter equipped with 900 MHz NG module Two antennas with 260 mm length each Operating voltage: 3.5 - 8.4 V Dimensions: 40 x 22 x 7 mm Weight: 11 g
Jeti Switch RC Power Switch 10A To switch a model on and off Controllable with DC/DS transmitter Simply switch on using a safety switch on the transmitter, confirm the safety query and you're done Can be used as a replacement for a standard switch No more need to open the model Indication of the switching status by means of red LED
Jeti Voltage controller Single BEC 1A For the supply of servos with a maximum voltage range of up to 6 volts up to the standard size on a HV receiving system Can also be used to supply multicopter or flight attitude control electronics without servos Due to its small dimensions and low weight, it is also suitable for small and medium-sized models or can be installed in a wide variety of model components (wings, tail units, fuselage) Applicable for servos with a force of up to 25 kg/cm
Jeti Micro switch magnetic 15A Suitable for switching the receiver power supply Maximum continuous current: 15 A Operating voltage: 4 - 8.4 V DC Light weight of 7 g Dimensions: 32 x 9 x 5 mm
Jeti Receiver Duplex REX 3 2.4 GHz EX, 100 mm antennas Bidirectional transmission Compatible with Duplex 2.4 EX and EX-Bus protocol Supports telemetry PPM input/output, UDI digital output and integrated expanders for EX/EX bus devices 2 antennas, each 100 mm long Suitable for use with a Jeti DS/DC transmitter or transmitter module
Jeti Receiver Duplex REX 12 EPC 2.4 GHz EX Bidirectional transmission Compatible with Duplex 2.4 EX and EX-Bus protocol Supports telemetry and has a separate high current connection PPM input/output, UDI digital output and integrated expanders for EX/EX bus devices 2 antennas, each 40 cm long Suitable for use with a Jeti DS/DC transmitter or transmitter module
Powerbox Systems Battery switch EVO with sensor switch Powerful battery backer with high continuous load capacity Consistent dual design of the power electronics Operating voltage: 4.0 - 9.0 V (intended for 2S LiXX or 5-cell NiMH batteries) Adjustable output voltage: 6 V, 7.4 V, 7.8 V, unregulated Dimensions: 89 x 55 x 18 mm Supported telemetry systems: P²BUS, S.BUS2, EX-Bus, SRXL2, M-Link, Hott, JR-DMS
Carson LED RACE Light unit With a total of 12 LEDs Turn signal front left/right 3 mm and turn signal rear left/right 3 mm Front light left/right 5 mm (4 LEDs) Taillight/brake light left/right 5 mm (4 LEDs) Demomode Futaba plug-in system suitable for Tamiya models
Jeti Switch DPS 40 Dual electronic switch with 2 battery inputs For switching supply voltages of receivers, servos, controllers and fuel pumps Higher vibration resistance and lower inherent contact resistance compared to mechanical switches, withstands an unlimited number of switching cycles High durability, as there are no moving parts such as contacts and are not susceptible to unexpected false tripping Operation by means of magnetic switch Can also be used for other DC switching tasks
Jeti V-cable MPX For 2 diode-separated power supplies on one receiver Also suitable for the separation of backup battery and controller BEC With MPX connector system Cable length: 15 cm each Cable cross section: 1 mm² Supply voltage/current load: maximum 16 V / 12 A
Jeti Receiver Duplex REX 9 Slim 2.4 GHz EX Compact design, ideal for F3J, F5J and similar models with limited space in the fuselage 9-channel 2.4 GHz duplex receiver, supports EX bus and telemetry 2 antennas with 200 mm length each Operating voltage: 3.5 - 8.4 V Weight: 13 g Dimensions: 60 x 16 x 13 mm
Jeti Receiver Duplex REX 6 Assist 2.4 GHz EX Telemetry data and up to 16 stabilized channels for model aircraft and multicopters Supports various copter configurations, from tricopter to octocopter, LED light strips based on WS2812 chips and external camera gimbals with servos Facilitates flying in windy or difficult conditions, aerobatic maneuvers are more accurate and therefore easier to fly without the need for complex setting of mixers Up to 3 adjustable flight modes with options for horizon stabilization and flight altitude Fine adjustment of stabilization settings in flight via a separate channel Use of 3-axis gyroscopes and 3-axis accelerometers
Jeti Power supply DSM ESC To supply the receiver and the servos Combines the BEC supply of two speed controllers/regulators or a combination of receiver battery (backup battery) and one BEC controller to supply the receiving system Switching on/off by means of magnetic switch Optional RC switch can also be used for switching